Using 2 MCMs, here called mcm0 and mcm1.
0 and 1 refers to which DTC link on SRU the mcm is on.
0 do in this case here refer to the upper location on tpc, 1 on lower.
Some problems with dtc1 link, to be understood.

The mcms were for comparison mounted on the smalltpc chamber,
and on a "free" padplane (i.e on the desk).

Pedestals when on chamber
-------------------------
mcm0-0-ped-chamber-fec01.pdf
mcm1-0-ped-chamber-fec01.pdf

Pedstals of mcm0 are roughlu twice as when on "free padplane".
All pedestals of mcm1 is wide, due to wavy events.
Chip 3 channels 0-7 om mcm0 have same width as mcm1, due to the wavy events.
See textfiles with extension .ped

Pedestals when on free padplane
-------------------------------
mcm0-0-ped-plane-fec01.pdf
mcm1-0-ped-plane-fec01.pdf
All pedestals have rms ca < 1.0. See textfiles with extension .ped
One channel (chip 6, channel8) in mcm0 have a pedestal of 400,
due to padplane/connector(?) since not seen before.

Individual events when on chamber
---------------------------------
mcm0-all-evt11-0-chamber-fec01-zoom.pdf
mcm1 was accidentily overwritten before saving data.
One can in mcm0 see the "wavy" structure, especially for chip 3.

Individual events when on free padplane
---------------------------------------
mcm0-all-evt11-1-plane-fec01-zoom.pdf
mcm1-all-evt11-1-plane-fec01-zoom.pdf
Normal look.